Each panel in our products is engineered to provide quick and easy assembly. All walk-ins are pre-assembled at our manufacturing facility to assure all locking mechanisms and panels join together efficiently. The end result is a quality, sealed walk-in unit when assembled at its final location. Our panels are then packaged to ensure a safe arrival at the job site.

Specifications

GENERAL

Walk-ins shall be constructed of prefab, precision-formed, modular panels designed for accurate, rapid field assembly. Walk-ins shall be test assembled at the factory. Walk-ins shall be equal to those manufactured by U.S. Cooler.

DRAWINGS AND INSTRUCTIONS

Each walk-in shall have a set of installation instructions and lay-out drawing. All panels shall have panel identification corresponding with the lay-out drawing to facilitate rapid and accurate field erection.

PANEL CONSTRUCTION

Each panel shall consist of inner and outer metal skins, a 4" insulation core, and be equipped with cam-action locking devices. The locking devices shall be operable from inside the walk-in and a hex-shaped wrench shall be supplied. Press-fit plug buttons shall be provided to seal wrench holes after assembly is complete. Construction shall be as approved by the National Sanitation Foundation International and shall bear the NSF® Seal of Approval.

All panels shall be connected to one another by placing the tongue of the insulation core of one panel into the groove of the core insulation of the adjacent panel. The resultant tongue and groove joint shall be sealed at both sides by double barreled NSF® approved gaskets. In order to avoid future swelling and mold formation, no wood shall be permitted in the manufacture of the tongue and groove panel profile.

Designer metal colors are available.

FLOOR SCREEDS

Floor screeds shall be provided for all floorless walk-ins. The screeds shall be vinyl, and have NSF® approved cove both inside and out.

PANEL FINISH

Metal finish of the panels shall be as follows. Interior or exterior walls, and ceilings

• black stucco embossed galvanized

INSULATION

Extruded Polystyrene: All wall and ceiling insulation shall be 4” thick, high quality, rigid extruded polystyrene, 1.6 lb density. K factor of not more than .139 and an Rfactor of not less than 7.2 per inch, initial fresh R-28.8 minimum total wall R factor. Vapor transmission shall be less than 1 perm and foam core material must meet UL 5 flame spread rating with average smoke rating less than 165. (UL 723)(UL 723)

BOX SIZE

6’10” x 4’10” x 7’6” without a floor

GLASS DOORS

Anthony Model 403B normal temp, 30”x81” lockable glass entry door with LED lights. 2-pane heat reflective with argon fill, trimline black handle and frame.

SHELVING

Shelving fits the back and two side walls, 3 shelves for each wall

REFRIGERATION

Pre-assembled outside refrigeration system, medium temperature, 1 phase, 3/4 horsepower, hermetic 208/230 volt, includes Copeland condensing unit.

BEER DISPENSING KIT

Aluminum CO2 tank (empty), keg coupler, double gauge CO2 regulator, chrome faucet head, faucet knob, 5” shank, beer line with connectors, air line with clamps, tap soother faucet cap, 6” wall mount drip tray (stainless steel with drain), drip tray dimensions: 11”H, 6”W, 4 3/4”D. Multiple faucet kits available.